Pre-Flight Calibration of the Mars 2020 Rover Mastcam Zoom (Mastcam-Z) Multispectral, Stereoscopic Imager

Research output: Contribution to journalReviewResearchpeer-review

Documents

  • Alexander G. Hayes
  • P. Corlies
  • C. Tate
  • M. Barrington
  • J. F. Bell
  • J. N. Maki
  • M. Caplinger
  • M. Ravine
  • K. Herkenhoff
  • B. Horgan
  • J. Johnson
  • M. Lemmon
  • G. Paar
  • M. S. Rice
  • E. Jensen
  • T. M. Kubacki
  • E. Cloutis
  • R. Deen
  • B. L. Ehlmann
  • E. Lakdawalla
  • R. Sullivan
  • A. Winhold
  • A. Parkinson
  • Z. Bailey
  • J. van Beek
  • P. Caballo-Perucha
  • E. Cisneros
  • D. Dixon
  • C. Donaldson
  • O. B. Jensen
  • J. Kuik
  • K. Lapo
  • A. Magee
  • J. Mollerup
  • N. Scudder
  • C. Seeger
  • E. Stanish
  • M. Starr
  • M. Thompson
  • N. Turenne
  • K. Winchell

The NASA Perseverance rover Mast Camera Zoom (Mastcam-Z) system is a pair of zoomable, focusable, multi-spectral, and color charge-coupled device (CCD) cameras mounted on top of a 1.7 m Remote Sensing Mast, along with associated electronics and two calibration targets. The cameras contain identical optical assemblies that can range in focal length from 26 mm (25.5 degrees x 19.1 degrees FOV) to 110 mm (6.2 degrees x 4.2 degrees FOV) and will acquire data at pixel scales of 148-540 mu m at a range of 2 m and 7.4-27 cm at 1 km. The cameras are mounted on the rover's mast with a stereo baseline of 24.3 +/- 0.1 cm and a toe-in angle of 1.17 +/- 0.03. (per camera). Each camera uses a Kodak KAI-2020 CCD with 1600x1200 active pixels and an 8 position filter wheel that contains an IR-cutoff filter for color imaging through the detectors' Bayer-pattern filters, a neutral density (ND) solar filter for imaging the sun, and 6 narrow-band geology filters (16 total filters). An associated Digital Electronics Assembly provides command data interfaces to the rover, 11-to-8 bit companding, and JPEG compression capabilities. Herein, we describe pre-flight calibration of the MastcamZ instrument and characterize its radiometric and geometric behavior. Between April 26th and May 9th, 2019, similar to 45,000 images were acquired during stand-alone calibration at Malin Space Science Systems (MSSS) in San Diego, CA. Additional data were acquired during Assembly Test and Launch Operations (ATLO) at the Jet Propulsion Laboratory and Kennedy Space Center. Results of the radiometric calibration validate a 5% absolute radiometric accuracy when using camera state parameters investigated during testing. When observing using camera state parameters not interrogated during calibration (e.g., non-canonical zoom positions), we conservatively estimate the absolute uncertainty to be <10%. Image quality, measured via the amplitude of the Modulation Transfer Function (MTF) at Nyquist sampling (0.35 line pairs per pixel), shows MTFNyquist = 0.26- 0.50 across all zoom, focus, and filter positions, exceeding the > 0.2 design requirement. We discuss lessons learned from calibration and suggest tactical strategies that will optimize the quality of science data acquired during operation at Mars. While most results matched expectations, some surprises were discovered, such as a strong wavelength and temperature dependence on the radiometric coefficients and a scene-dependent dynamic component to the zero-exposure bias frames. Calibration results and derived accuracies were validated using a Geoboard target consisting of well-characterized geologic samples.

Original languageEnglish
Article number29
JournalSpace Science Reviews
Volume217
Issue number2
Number of pages95
ISSN0038-6308
DOIs
Publication statusPublished - 1 Mar 2021

    Research areas

  • Calibration, Camera, Mars

Number of downloads are based on statistics from Google Scholar and www.ku.dk


No data available

ID: 258324937